Jump to content

Stereoscopic Horizon Adjustments


mark82
 Share

Recommended Posts

Can't figure out how to properly align the distant horizon. I can move into place horizontally holding using the shift key... but my vertical alignment is a little off. The vertical alignment tool works okay... but with the 6 lenses on the Insta360 Pro2, it is complicated as an adjustment on one lens will effect the vertical alignment on the other lens... and so the adjusting can go on forever. What am I doing wrong? I have seen and/or read every post I can find... including all tutorials from SGO and from Hugh.  Any suggestions? I'm really close at this point...it's almost there.  Normally, I would let adobe premiere and the Insta360 Pro stitcher plugin handle it... but on this particular video, the gyro went crazy after about 1 minute and so that is not an option. See attached images of the vertical alignment issue and also a screenshot of the stabilization from the camera after about 1 minute.

Screen Shot 2020-09-14 at 3.10.18 PM.png

Screen Shot 2020-09-14 at 3.10.31 PM.png

Screen Shot 2020-09-14 at 3.11.44 PM.png

Link to comment
Share on other sites

  • 4 months later...
 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.